Yaskawa SGDH Linear Sigma Series - Manual (Page 44)

2 Selections
2.6.1 Special Options
2-10
* For details, refer to the manuals of each application module.
**The 50-pin female D-sub output connector mates to a customer-supplied 3rd party terminal block. (e.g.,
Wago #289-449, Weidmuller #919658, Phoenix #2283647, Amphenol/Sine #20-51039, and many oth-
ers)
Name Length Type Specifications
Refer-
ence
c
I/O Signal
Cables
Connector terminal block
converter unit
JUSP-TA50P
Terminal block and 0.5 m connection
cable
6.8.4
Cable with
loose wires at
one end
1 m JZSP-CKI01-1 Loose wires at host controller end
6.7.1 2 m JZSP-CKI01-2
3 m JZSP-CKI01-3
Cable with Female D-sub Output
Connector**
0.5m JZSP–CKI0D–D50
Cable
–
1m JZSP–CKI0D–01
2m JZSP–CKI0D–02
3m JZSP–CKI0D–03
d
Digital Operator JUSP-OP02A-2
With connection cable (1 m)
6.8.2
e
Connection Cable
for Digital Operator
1 m JZSP-CMS00-1
Only required when using Σ series
Digital Operator JUSP-OP02A-1.
f
Connection Cable for Personal
Computer
2 m YS-12
D-Sub 9-pin (For DOS/V)
6.8.1
g
Analog Monitor Cable
1 m
JZSP-CA01
(or DE9404559)
6.8.3
Name Type
Refer-
ence
h
Application Module ∗
MECHATROLINK-I Application Module
(NS100)
JUSP-NS100 6.8.10
MECHATROLINK-II Application Module
(NS115)
JUSP-NS115 6.8.10
DeviceNet Application Module (NS300) JUSP-NS300 6.8.11
PROFIBUS-DP Application Module (NS500) JUSP-NS500 6.8.12
INDEXER Application Module (NS600) JUSP-NS600 6.8.13
CN1
CN3
Operator
end
SERVOPACK
end
CN3 Personal
computer end
SERVOPACK
end
CN5
SERVOPACK end Monitor end