Yaskawa SGDH Linear Sigma Series - Manual (Page 333)

10.2 Online Autotuning
10-11
10
10.2.7 Procedure for Saving the Results of Online Autotuning
The following procedure is used to save the results of online autotuning.
This completes saving the default value for the mass ratio for online autotuning. The next time the power supply
is turned ON, the value that was saved for the Mass Ratio (Pn103) will be used to start online autotuning.
Step Display after Operation Digital Operator Panel Opera-
tor
Description
1 Press the DSPL/SET or MODE/SET Key to select the utility
function mode.
2 Press the Up or Down Cursor Key to select parameter Fn007.
*The digit that can be set will blink.
3 Press the DATA/ENTER or DATA/SHIFT Key for one second
or more.
The display at the left will appear for a mass ratio of 200%.
4 Press the DSPL/SET or MODE/SET Key.
The mass ratio will be saved.
When completed, “donE” will blink for about one second.
5 About one second later After “donE” is displayed, the mass ratio will be displayed
again.
6 Press the DATA/ENTER or DATA/SHIFT Key for one second
or more to return to the Fn007 display of the utility function
mode.
DSPL
SET
(DSPL/SET Key)
MODE/SET
(MODE/SET Key)
DATA
ENTER
(DATA/ENTER Key)
DATA/
(DATA/SHIFT Key)
(Press at least 1 s.)
DSPL
SET
(DSPL/SET Key)
MODE/SET
(MODE/SET Key)
DATA
ENTER
(DATA/ENTER Key)
DATA/
(DATA/SHIFT Key)
(Press at least 1 s.)