Yaskawa SGDH Linear Sigma Series - Manual (Page 414)

12 Appendix
12.4.2 List of Parameters
12-38
* Available for the software version 32 or later
Pn510 Output Signal Selection 3 − − 0000 After
restart
9.8.6
Pn512 Output Signal Reverse Settings − − 0000 After
restart
8.3.3
Parameter
No.
Name Setting Range Unit
Factory
Setting
Setting
Validation
Reference
Section
0
1
2
3
Disabled (the above signal is not used.)
Outputs the signal from CN1-25, -26 terminal.
Outputs the signal from CN1-27, -28 terminal.
Outputs the signal from CN1-29, -30 terminal.
Near Signal Mapping (/NEAR)
0 to 3 Same as /NEAR
Reference Pulse Input Switch Signal Mapping (/P-SELA)
∗
4th
digit
3rd
digit
2nd
digit
1st
digit
n.
Reserved (Do not change)
Reserved (Do not change)
0
1
0
1
0
1
Output signal is not reversed.
Output signal is reversed.
Output signal is not reversed.
Output signal is reversed.
Output signal is not reversed.
Output signal is reversed.
Output Signal Reverse for CN1-25 or -26 Terminals
4th
digit
3rd
digit
2nd
digit
1st
digit
n.
Output Signal Reverse for CN1-27 or -28 Terminals
Output Signal Reverse for CN1-29 or -30 Terminals
Reserved (Do not change)