HEIDENHAIN IK 5394-3D - Manual (Page 554)

A-10
Appendix A Profile measurement
Entering part data from the Measure Profile window
As points are acquired they appear (in green) in the Measure Profile window,
as shown in this example of a video circle measurement.
Video tools are typically fired from the Video window, however, they can
also be fired from the Measure Profile window.
Position the video tool over the desired feature in the
Video window and click the Enter Pt button in the
Measure Profile window.
Importing point data from the Features template
Point data that were previously measured can be imported to the Measure
Profile window from the Features template.
Select the desired features in the Features template and
click the Import Pts button.
Removing the last data point entered
The last data points entered into the Measure Profile
window can be removed by clicking the Remove Last
button.
Multiple data points can be removed by repeatedly clicking the Remove Last
button, until no points remain.
Firing a tool in the Video window... Causes points to appear in the
Measure Profile window
Circle points from the
Features template...
are imported to the Measure Profile
window