HEIDENHAIN IK 5394-3D - Manual (Page 392)

5-32
Chapter 5 Tolerancing & Templates
Circular runout tolerance
Use circular runout to set a tolerance of how far circular features may deviate
from the center of a reference feature in 360 degrees of rotation.
To perform a circular runout tolerance
Step 1
Highlight the desired feature in the features list.
NOTE
Use a circle only. Circular runout tolerances do not apply to
other types of features.
Step 2
Click the circular runout button on the tolerance toolbar.
Step 3
Enter a value in the tolerance zone box as shown.
CAUTION
Enter tolerance values in the appropriate units of measurement.
For example, if you are measuring in metric (mm) enter tolerance
data in metric (mm).