HEIDENHAIN IK 5394-3D - Manual (Page 465)

6 - 15
Quadra-Chek ® 5000
Errors screen
Error messages can be displayed that describe most system errors. These mes-
sages are listed below.
NOTE
The error messages are not necessarily listed in their order of
appearance in the Error screen list box.
System error messages
• Temperature Compensation should be disabled before doing any kind of Teach or Calibration.
• NC control off.
• A Device Driver is either not installed on your PC, or is not working properly. Because of this, the Axis
Cards will not work.
• An Axis Card is either not installed on your PC, or is not working properly. Because of this the DRO will
not work, and measurements can only be probed using the Demo Stage (located under the Windows
menu).
• A scale error has occurred on your X axis.
• A scale error has occurred on your Y axis.
• A scale error has occurred on your Z axis.
• A scale error has occurred on your Q axis.
• A hardware error has occurred while trying to read your Axis Card.
• The measurement failed.
• This arc measurement may not be repeatable due to short arc length.
• This line measurement may not be repeatable due to short line length.
• This measurement may not be repeatable due to short axis length.
• This construction is not currently supported.
• There are one or more statistical outlier points in this measurement.
• This distance is valid only in the cardinal directions.
• Poor form - No feature was found for these points.
• Warning: result has poor form.
• The features you have selected are on different projection planes. The result will be 3-D.
• Insufficient data - this result could only be approximated.
• The position of the material is ambiguous.
• This alignment can be done only in the primary workplane.
• This alignment will delete magnetic planes.
• This alignment may convert projected features to 3-D.
• Projection must be on to measure this feature.
• The result is out of range.
• There is no intersection between these features.
• Lines intersect.
• The points probed in Measure Magic do not make a good enough feature of that type.
• Datum Magic could not complete successfully because an invalid feature type was measured.
• This alternate fit computation failed
• Please use the blob probe for this measurement
• Cannot complete programmed move
• You can’t use the crosshair probe while using Measure Magic or Datum Magic.
• The magnification that you are in has not been calibrated. The points that are about to be entered into
the measurement may be invalid.
• Sorry, but motors are currently turned off.
• A following error has occurred on your X axis.