HEIDENHAIN IK 5394-3D - Manual (Page 466)

6 - 16
Chapter 6 System Setup
• A following error has occurred on your Y axis.
• A following error has occurred on your Z axis.
• A following error has occurred on your Q axis.
• A limit switch on the X axis has been hit!
• A limit switch on the Y axis has been hit!
• A limit switch on the Z axis has been hit!
• A limit switch on the Q axis has been hit!
Any of these error messages can be disabled by clearing their check boxes. All
error messages can be disabled simultaneously by checking the Disable all sys-
tem error messages box.
All error messages are enabled by default.