HEIDENHAIN IK 5394-3D - Manual (Page 315)

Quadra-Chek ® 5000
4-43
Velocity factor
Probing %:
percent of the max speed the stage will move as it takes touch probe points.
Non-probing %
speed the stage moves when not probing. This is generally set to 100%.
Approach
the point at which the system transitions from non-probing speed to probing
speed.
Search
distance the system will continue probing to acquire a probe hit beyond the
nominal coordinate.
Retract
distance the probe will retract upon making contact with the part.
Depth
Not Implemented for this release.
Clearance
Not implemented for this release.
Switch to magnification
sets the active VED magnification as the default magnification for the part.
Select probe
Sets the active touch probe as the default touch probe for the part.
Filtering
Inserts the values and toggles on/off the 4 image analysis filters.
Turn off high accuracy mode
Notes if high accuracy mode is on or off at the beginning of the program.
Focus lock
Notes if focus lock is on or off at the beginning of the program.
Display linear values in millimeters
Notes current units (inches or mm) at the beginning of the program.
Display positions in cartesian coordinates
Notes the current coordinate system (polar or cartesian) at the beginning of the
program.
Display angles in degrees-minutes-seconds
Notes the current angle display (decimal degrees or degrees-minutes-seconds) at
the beginning of the program.
Set probe compensation to cardinal
Notes the current probe compensation (cardinal or polar) at the beginning of
the program.