HEIDENHAIN IK 5394-3D - Manual (Page 262)

3-90
Chapter 3 Probes
Step 2
Click OK in the dialog box.
NOTE
Re-adjust the orientation of the probe rack if the angle of the
line is greater than 1.0 degree from the nominal orientation.
Run the desired DATRACK part program.
To run the DATRACK program
NOTE
Use a 2mm probe tip with a 20 mm stylus when running the
DATRACK program.
Step 1
Select open from the file menu.
Step 2
Select the desired DATRACK program as shown.