HEIDENHAIN IK 5394-3D - Manual (Page 493)

6 - 43
Quadra-Chek ® 5000
Enabling sounds during program execution
System sounds configured in the Sounds Options screen alert the operator to
various conditions during program execution. These sounds can be enabled or
disabled in the Programming Options screen.
Click the Make sounds... box to enable
sounds during program execution.
Specifying the minimum percentage of VED points
VED tools generate up to the maximum number of points specified in the
Measure Options screen when fired on a feature edge. Fewer than the maxi-
mum number might actually be generated when a program is recorded depend-
ing on the video tool used and the sharpness of the edge being measured. Mea-
surement failures occur when the number of points missed during program
execution equals or exceeds the specified percentage of points generated when
the program was recorded.
For example, when 40% is specified, 60% of the points generated when the
program was recorded must be collected when the program is executed.
Specify the percentage of points that can be missed in the A probe firing... field.
NOTE
The default value should only be changed by qualified product
support personnel.
Specifying CNC movement warnings
Users can be warned prior to the first CNC movement executed by a program as
a means of avoiding probe collisions.
Click the Warn user on the first CNC
movement box to enable warnings.
Delaying VED tool firing after CNC moves
Settling time can be included in programs to eliminate the effects of machine
vibration caused by CNC stage movements if necessary.
Enter the settling time delay into the Delay in firing... field.