HEIDENHAIN IK 5394-3D - Manual (Page 313)

Quadra-Chek ® 5000
4-41
General tab
The general tab contains the following checkboxes:
•
Use machine reference frame
•
Empty feature list before running
•
Use probe teach values as recorded
•
Do not report any errors during program running
•
Prevent program from being modified by anyone but the supervisor
•
On a measurement failure goto label
•
Randomly measure this percent of guide features
Use machine reference frame
Check to use machine zero at the start of a program. Uncheck to use part zero.
Empty feature list before running
Check to delete all features from the features list before running.
Use probe teach values as recorded
Check to use previously recorded probe teaches.
Do not report any errors during program running
Check to ignore all errors while running the program
Prevent program from being modified by anyone but the supervisor
Check to require the supervisor password from users before allowing changes.
On a measurement failure goto label
Check to create a goto step if a measurement fails.
Randomly measure this percent of guide features
Used to measure a random number of features on a part, normally guide fea-
tures are features that are never measured except in this special case where a
percentage of them will be.