HEIDENHAIN IK 5394-3D - Manual (Page 364)

5-4
Chapter 5 Tolerancing & Templates
Step 4
Type in the nominal + and nominal - values for your feature as shown.
NOTE
Nominal + and - values are the same as the tolerance value for
the feature. For example, if a feature has a tolerance of + or -
0.006 inches then the nominal + and nominal - values are 0.006
inches.
CAUTION
Enter tolerance values in the appropriate units of measurement.
For example, if you are measuring in metric (mm) enter tolerance
data in metric (mm).
Step 5
Click OK in the dialog box.
The tolerance result window appears as shown.