HEIDENHAIN IK 5394-3D - Manual (Page 542)

6 - 92
Chapter 6 System Setup
3 Click the line again to automatically insert the current probe into the pro-
gram in place of the original probe.
Click the New Run button on the program toolbar
to run the edited program.
When the DATRACK program runs, the user will be prompted to complete
several tasks. Use the following procedures to complete the DATRACK pro-
gram.
Entering the datum in the DATRACK program
1 Click OK to acknowledge reference frame creation.
2 You will be instructed to open the rack port covers. Click OK and open the
port covers.