beautypg.com

6 workpiece setup, Selecting the correct operating mode, Clamp the workpiece – HEIDENHAIN iTNC 530 (34049x-08) ISO programming User Manual

Page 75: 6 w o rk piece set u p 1.6 workpiece setup

background image

HEIDENHAIN iTNC 530

75

1

.6 W

o

rk

piece set

u

p

1.6 Workpiece setup

Selecting the correct operating mode

Workpieces are set up in the Manual Operation or Electronic
Handwheel

mode

Press the Manual Operation operating mode key: the

TNC switches to that mode.

Further information on this topic

Manual Operation mode: See "Moving the machine axes" on page

467

Clamp the workpiece

Mount the workpiece with a fixture on the machine table. If you have

a touch probe on your machine, then you do not need to clamp the

workpiece parallel to the axes.
If you do not have a touch probe available, you have to align the

workpiece so that it is fixed with its edges parallel to the machine

axes.

See also other documents in the category HEIDENHAIN Equipment: