HEIDENHAIN iTNC 530 (34049x-08) ISO programming - Manual (Page 181)

HEIDENHAIN iTNC 530 181
5.2 T
ool data
Tool-carrier kinematics
In the KINEMATIC column of the tool table TOOL.T you can assign each
tool with an additional tool carrier kinematic description. In the
simplest case, this carrier kinematics can simulate the taper shank in
order to include it in the dynamic collision monitoring. Also, you can
use this function to very easily integrate angle heads into the machine
kinematic description.
Assigning the tool-carrier kinematics
Follow the procedure below to assign carrier kinematics to a tool:
 Select any machine operating mode
 Select the tool table: Press the TOOL TABLE soft key
 Set the EDIT soft key to ON
 Select the last soft key row
 Show the list of available kinematics: The TNC
displays all tool holder kinematics (.TAB files) and all
tool-holder kinematics you have already
parameterized (.CFX files)
 Select the desired kinematics configuration with the
arrow keys and confirm your selection with the OK
key.
The TNC must be adapted by your machine tool builder to
be able to account for the tool carrier kinematics. In
particular, your machine tool builder must provide the
corresponding carrier kinematics or parameterizable tool
carriers. Refer to your machine manual.
HEIDENHAIN provides tool-carrier kinematics for
HEIDENHAIN touch probes. If required, please contact
HEIDENHAIN.
Please also note the information on tool-carrier
management in combination with Dynamic Collision
Monitoring (DCM): See "Tool carrier management (DCM
software option)" on page 365.