6 optional block skip, Application, Erasing the "/" character – HEIDENHAIN iTNC 530 (34049x-08) ISO programming User Manual

Page 554: Application erasing the "/" character, 6 optional bloc k skip 16.6 optional block skip

554

Test run and program run

16.6 Optional bloc

k skip

16.6 Optional block skip

Application

In a test run or program run, the control can skip over blocks that begin

with a slash "/":



To run or test the program without the blocks

preceded by a slash, set the soft key to ON



To run or test the program with the blocks preceded

by a slash, set the soft key to OFF

Erasing the "/" character



In the Programming and Editing mode you select the block in which

the character is to be erased



Erase the "/" character

This function does not work for TOOL DEF blocks.
After a power interruption the control returns to the most

recently selected setting.