Changed functions in version 34049x-06 – HEIDENHAIN iTNC 530 (34049x-08) ISO programming User Manual
Page 18
Chang
e
d functions in v
e
rsion 34049x
-06
18
Changed functions in version
34049x-06
The new HR 520 and HR 550 FS handwheels are supported (see
"Traversing with electronic handwheels" on page 469)
New software option 3-D ToolComp: 3-D tool radius compensation
depending on the tool’s contact angle on blocks with surface normal
vectors (LN blocks)
3-D line graphics is now also possible in full-screen mode (see "3-D
line graphics (FCL2 function)" on page 152)
A file selection dialog for selecting files in different NC functions and
in the table view of the pallet table is available now (see "Calling any
program as a subprogram" on page 261)
DCM: Saving and restoring of fixture situations
DCM: The form for test program generation now also contains icons
and tooltips (see "Checking the position of the measured fixture" on
DCM, FixtureWizard: Touch points and probing sequence are shown
more clearly now
DCM, FixtureWizard: Designations, touch points and measuring
points can be shown or hidden as desired (see "Operating
DCM, FixtureWizard: Chucking equipment and insertion points can
now also be selected by mouse click
DCM: A library with standard chucking equipment is available now
(see "Fixture templates" on page 356)
DCM: Tool carrier management (see "Tool carrier management
(DCM software option)" on page 365)
In the Test Run mode, the working plane can now by defined
manually (see "Setting a tilted working plane for the test run" on
In Manual mode the RW-3D mode for position display is now also
available (see "Position display types" on page 584)
Entries in the tool table TOOL.T (see "Tool table: Standard tool data"
New DR2TABLE column for definition of a compensation table for
tool radius compensation depending on the tool’s contact angle
New LAST_USE column, into which the TNC enters the date and
time of the last tool call
Q parameter programming: QS string parameters can now also be
used for jump addresses of conditional jumps, subprograms or
program section repeats (see "Calling a subprogram", page 259, see
"Calling a program section repeat", page 260 and see "Programming
The generation of tool usage lists in the Program Run modes can be
configured in a form (see "Settings for the tool usage test" on page
The behavior during deletion of tools from the tool table can now be
influenced via machine parameter 7263 see "Editing tool tables",