HEIDENHAIN iTNC 530 (34049x-08) ISO programming - Manual (Page 479)

HEIDENHAIN iTNC 530 479
14.3 Spindle speed S
, f
eed r
a
te
F and miscellaneous functions M
14.3 Spindle speed S, feed rate F
and miscellaneous functions M
Function
In the Manual Operation and El. Handwheel operating modes, you can
enter the spindle speed S, feed rate F and the miscellaneous functions
M with soft keys. The miscellaneous functions are described in
Chapter 7 "Programming: Miscellaneous functions."
Entering values
Spindle speed S, miscellaneous function M
Enter the spindle speed: Press the S soft key
Enter the desired spindle speed and confirm your
entry with the machine START button
The spindle speed S with the entered rpm is started with a
miscellaneous function M. Proceed in the same way to enter a
miscellaneous function M.
Feed rate F
After entering a feed rate F, you must confirm your entry with the ENT
key instead of the machine START button.
The following is valid for feed rate F:
 If you enter F=0, then the lowest feed rate from MP1020 is effective
 F is not lost during a power interruption
The machine tool builder determines which
miscellaneous functions M are available on your control
and what effects they have.
SPINDLE SPEED S =
1000