HEIDENHAIN iTNC 530 (34049x-08) ISO programming - Manual (Page 635)

HEIDENHAIN iTNC 530 635
1
9
.2 Star
ting an iTNC 530 application
19.2 Starting an iTNC 530
application
Logging on to Windows
After you have switched on the power supply, the iTNC 530 starts
booting automatically. When the input dialog for logging on to
Windows appears, there are two possibilities for logging on:
 Logging on as a TNC user
 Logging on as a local administrator
Logging on as a TNC user
 Enter the user name "TNC" in the User name input box. Leave the
Password
input box blank and press the OK button.
 The TNC software is automatically started. The status message
Starting, please wait...
appears in the iTNC Control Panel.
Do not open or use any other Windows programs as long
as the iTNC Control Panel is displayed (see figure). When
the iTNC software has successfully started, the Control
Panel minimizes itself to a HEIDENHAIN symbol on the
task bar.
This user identification permits very limited access to the
Windows operating system. You are neither allowed to
change the network settings, nor are you allowed to install
new software.