Changed functions in version 34049x-03 – HEIDENHAIN iTNC 530 (34049x-08) ISO programming User Manual
Page 26
Chang
e
d functions in v
e
rsion 34049x
-03
26
Changed functions in version
34049x-03
In Cycle 22 you can now define a tool name also for the coarse
roughing tool (see User's Manual for Cycles)
In the PLANE function, an FMAX can now be programmed for the
automatic rotary positioning (see "Automatic positioning:
MOVE/TURN/STAY (entry is mandatory)" on page 426)
When running programs in which non-controlled axes are
programmed, the TNC now interrupts the program run and displays
a menu for returning to the programmed position (see
"Programming of noncontrolled axes (counter axes)" on page 546)
The tool usage file now also includes the total machining time,
which serves as the basis for the progress display in percent in the
Program Run, Full Sequence mode
The TNC now also takes the dwell time into account when
calculating the machining time in the Test Run mode (see
"Measuring the machining time" on page 535)
Arcs that are not programmed in the active working plane can now
also be run as spatial arcs (see "Circular path C around circle center
CC" on page 221)
The EDIT OFF/ON soft key on the pocket table can be deactivated
by the machine tool builder (see "Pocket table for tool changer" on
The additional status display has been revised. The following
improvements have been made (see "Additional status displays" on
A new overview page with the most important status displays
was introduced
The individual status pages are now displayed as tabs (as in
smarT.NC). The individual tabs can be selected with the Page soft
keys or with the mouse
The current run time of the program is shown in percent by a
progress bar
The tolerance values set in Cycle 32 are displayed
Active global program settings are displayed, provided that this
software option was enabled
The status of the Adaptive Feed Control (AFC) is displayed,
provided that this software option was enabled