New functions in version 34049x-02 – HEIDENHAIN iTNC 530 (34049x-08) ISO programming User Manual
Page 12
New functions in v
e
rsion 34049x
-02
12
New functions in version 34049x-02
DXF files can be opened directly on the TNC, in order to extract
contours into a plain-language program (see "Processing DXF files
(software option)" on page 238)
3-D line graphics are now available in the Programming and Editing
operating mode (see "3-D line graphics (FCL2 function)" on page
The active tool-axis direction can now be set as the active machining
direction for manual operation (see "Setting the current tool-axis
direction as the active machining direction (FCL 2 function)" on page
The machine manufacturer can now define any areas on the
machine for collision monitoring (see "Dynamic Collision Monitoring
(software option)" on page 349)
Instead of the spindle speed S you can now define the cutting speed
Vc in m/min (see "Calling tool data" on page 186)
The TNC can now display freely definable tables in the familiar table
view or as forms
The function for converting FK programs to H was expanded.
Programs can now also be output in linearized format
You can filter contours that were created using external
programming systems
For contours which you connect via the contour formula, you can
now assign separate machining depths for each subcontour (see
User's Manual for Cycles)
The single-processor version now supports not only pointing
devices (mice), but also USB block devices (memory sticks, disk
drives, hard disks, CD-ROM drives) (see "USB devices on the TNC