HEIDENHAIN iTNC 530 (34049x-08) ISO programming - Manual (Page 175)

HEIDENHAIN iTNC 530 175
5.2 T
ool data
Tool table: Tool data required for automatic tool measurement
For a description of the cycles for automatic tool
measurement, see the User's Manual for Cycle
Programming.
Abbr. Inputs Dialog
CUT Number of teeth (99 teeth maximum)
Input range : 0 to 99
Number of teeth?
LTOL Permissible deviation from tool length L for wear detection. If the
entered value is exceeded, the TNC locks the tool (status L). Input
range: 0 to 0.9999 mm
Input range in mm : 0 to +0.9999
Input range in inches : 0 to +0.03936
Wear tolerance: length?
RTOL
Permissible deviation from tool radius R for wear detection. If the
entered value is exceeded, the TNC locks the tool (status L). Input
range: 0 to 0.9999 mm
Input range in mm : 0 to +0.9999
Input range in inches : 0 to +0.03936
Wear tolerance: radius?
R2TOL Permissible deviation from tool radius R2 for wear detection. If
the entered value is exceeded, the TNC locks the tool (status L).
Input range: 0 to 0.9999 mm
Input range in mm : 0 to +0.9999
Input range in inches : 0 to +0.03936
Wear tolerance: Radius 2?
DIRECT. Cutting direction of the tool for measuring the tool during rotation Cutting direction (M3 = –)?
TT:R-OFFS Tool length measurement: Tool offset between stylus center and
tool center. Preset value: Tool radius R (NO ENT means R).
Input range in mm : –99999.9999 to +99999.9999
Input range in inches : –3936.9999 to +3936.9999
Tool offset: radius?
TT:L-OFFS
Radius measurement: tool offset in addition to MP6530 between
upper surface of stylus and lower surface of tool. Default: 0
Input range in mm : –99999.9999 to +99999.9999
Input range in inches : –3936.9999 to +3936.9999
Tool offset: length?