HEIDENHAIN iTNC 530 (34049x-08) ISO programming - Manual (Page 623)

HEIDENHAIN iTNC 530 623
1
8
.3 T
ec
hnical inf
o
rm
ation
Actual position capture  Actual positions can be transferred directly into the NC program
Program verification graphics
Display modes
Graphic simulation before program run, even while another program is being run
 Plan view / projection in 3 planes / 3-D view
 Magnification of details
Programming graphics  In the Programming and Editing mode, the contours of the NC blocks are drawn on
screen while they are being entered (2-D pencil-trace graphics), even while another
program is running
Program Run graphics
Display modes
 Graphic simulation of real-time machining in plan view / projection in 3 planes /
3-D view
Machining time  Calculating the machining time in the Test Run mode of operation
 Display of the current machining time in the Program Run modes
Returning to the contour  Mid-program startup in any block in the program, returning the tool to the calculated
nominal position to continue machining
 Program interruption, contour departure and return
Datum tables  Multiple datum tables
Pallet tables  Pallet tables (with as many entries as desired for the selection of pallets, NC programs
and datums) can be machined workpiece by workpiece or tool by tool
Touch probe cycles  Calibrate touch probe
 Compensation of workpiece misalignment, manual or automatic
 Datum setting, manual or automatic
 Automatic workpiece measurement
 Cycles for automatic tool measurement
 Cycles for automatic kinematics measurement
Specifications
Components  MC 422D main computer
 CC 422 or CC 424 controller unit
 Operating panel
 15.1-inch
Program memory At least 21 GB, up to 130 GB depending on main computer
Input resolution and display
step  Up to 0.1 µm for linear axes
 Up to 0.0001° for rotary axes
Input range  Maximum 99 999.999 mm (3.937 inches) or 99 999.999°
User functions