HEIDENHAIN iTNC 530 (34049x-08) ISO programming User Manual
Page 11
New functions in v
e
rsion 34049x
-0
1 since the pr
edecessor v
e
rsions
340422-xx/340423-xx
HEIDENHAIN iTNC 530
11
New functions in version 34049x-01
since the predecessor versions
340422-xx/340423-xx
A new form-based operating mode, smarT.NC, has been
introduced. These cycles are described in a separate user's
document. In connection with this the TNC operating panel was
enhanced. There are some new keys available for quicker navigation
within smarT.NC
The single-processor versions supports pointing devices (mice) via
the USB interface
The tooth feed f
z
and feed per revolution f
u
can now be defined as
alternate feed entries
New Cycle CENTERING (see User’s Manual for Cycles)
New M function M150 for suppressing limit switch messages (see
"Suppressing the limit switch message: M150" on page 342)
M128 is now also permitted for mid-program startup (see "Mid-
program startup (block scan)" on page 549)
The number of available Q parameters was expanded to 2000 (see
"Principle and overview" on page 274)
The number of available label numbers was expanded to 1000. Now
label names can be assigned as well (see "Labeling subprograms
and program section repeats" on page 258)
In the Q parameter functions FN9 to FN12 you can now also assign
label names as jump targets (see "If-then decisions with
Selectively machine points from a point table (see User's Manual for
Cycles)
The current time is also shown in the additional status display
window (see "General program information (PGM tab)" on page 90)
Several columns were added to the tool table (see "Tool table:
Standard tool data" on page 171)
The Test Run can now also be stopped and resumed within