HEIDENHAIN iTNC 530 (34049x-08) ISO programming - Manual (Page 29)

Chang
e
d functions in v
e
rsion 34049x
-06
HEIDENHAIN iTNC 530 29
Changed functions in version
34049x-06
 In the calibration menus for touch probe length and radius, the
number and name of the active tool are also displayed now (if the
calibration data from the tool table are to be used, MP7411 = 1, see
"Managing more than one block of calibrating data", page 496)
 During tilting in the Distance-To-Go mode, the PLANE function now
shows the angle actually left to be traversed until the target position
(see "Position display" on page 411)
 The approach behavior during side finishing with Cycle 24 (DIN/ISO:
G124) was changed (see User's Manual for Cycle Programming)