HEIDENHAIN iTNC 530 (34049x-08) ISO programming - Manual (Page 489)

HEIDENHAIN iTNC 530 489
14.5 Using t
o
uc
h-pr
obes
14.5 Using touch-probes
Overview
The following touch probe cycles are available in the Manual Operation
mode:
Please note that HEIDENHAIN grants a warranty for the
function of the touch probe cycles only if HEIDENHAIN
touch probes are used!
Function Soft key Page
Calibrating the effective length Page 494
Calibrating the effective radius Page 495
Measuring a basic rotation using a line Page 499
Setting the datum in any axis Page 503
Setting a corner as datum Page 504
Setting a circle center as datum Page 505
Setting a center line as datum Page 506
Measuring a basic rotation using two
holes/cylindrical studs
Page 507
Setting the datum using four
holes/cylindrical studs
Page 507
Setting a circle center using three
holes/cylindrical studs
Page 507