HEIDENHAIN TNC 128 (77184x-02) - Manual (Page 92)

Programming: Fundamentals, file management
3.2 Opening and entering programs
3
92
TNC 128 | User's Manual HEIDENHAIN Conversational Programming | 5/2014
Marking, copying, cutting and inserting program sections
The TNC provides certain functions for copying program sections
within an NC program or into another NC program—see the table
below.
To copy a program section, proceed as follows:
Select the soft-key row containing the marking functions
Select the first block of the section you wish to copy
Mark the first block: Press the
SELECT BLOCK soft key. The TNC
then highlights the block and displays the
CANCEL SELECTION
soft key
Move the highlight to the last block of the program section you
wish to copy or cut. The TNC shows the marked blocks in a
different color. You can end the marking function at any time by
pressing the
CANCEL SELECTION soft key
Copy the selected program section: Press the
COPY BLOCK soft
key. Cut the selected program section: Press the
CUT BLOCK
soft key. The TNC stores the selected block
Using the arrow keys, select the block after which you wish to
insert the copied (cut) program section
To insert the section into another program, select the
corresponding program using the file manager and
then mark the block after which you wish to insert
the program section.
Insert the saved program section: Press the INSERT BLOCK soft
key
To end the marking function, press the
Cancel selection soft
key