HEIDENHAIN TNC 128 (77184x-02) - Manual (Page 293)

Using 3-D touch probes (Touch Probe Functions software option 17) 11.5
11
TNC 128 | User's Manual HEIDENHAIN Conversational Programming | 5/2014
293
11.5 Using 3-D touch probes (Touch Probe
Functions software option 17)
Overview
The following touch probe cycles are available in the
Manual
Operation mode:
HEIDENHAIN only gives warranty for the function of
the probing cycles if HEIDENHAIN touch probes are
used.
The TNC must be specially prepared by the machine
tool builder for the use of a 3-D touch probe. Refer to
your machine manual. Refer to your machine manual.
The touch probe cycles are available only with the
Touch Probe Functions software option (option
number 17). If you are using a HEIDENHAIN touch
probe, this option is available automatically.
Function Soft key Page
Calibrating the effective length 301
Setting a datum in any axis 305
Setting a circle center as datum 306
Setting the centerline as datum 308
Touch probe system data
management 474