HEIDENHAIN TNC 128 (77184x-02) - Manual (Page 346)

MOD functions
14.1 MOD function
14
346
TNC 128 | User's Manual HEIDENHAIN Conversational Programming | 5/2014
14.1 MOD function
The MOD functions provide additional input possibilities and
displays. In addition you can enter code numbers to enable access
to protected areas.
The available MOD functions depend on the selected operating
mode.
Selecting MOD functions
Open the pop-up window with the MOD functions:
To select the MOD functions, Press the
MOD key.
The TNC opens a pop-up window displaying the
available MOD functions.
Changing the settings
There are three possibilities for changing a setting, depending on
the function selected:
Enter a numerical value directly, e.g. when determining the
traverse range limit
Change a setting by pressing the ENT key, e.g. when setting
program input
Change a setting via a selection window
If more than one possibility is available for a particular
setting, you can superimpose a window listing all
of the given possibilities by pressing the GOTO key.
Select the setting with the ENT key. If you don't want
to change the setting, close the window again with
END.
Exiting MOD functions
To close the MOD functions, Press the END or
END key