HEIDENHAIN TNC 128 (77184x-02) - Manual (Page 440)

Fixed cycles: Pocket milling / stud milling
17.4 FACE MILLING (Cycle 233)
17
440
TNC 128 | User's Manual HEIDENHAIN Conversational Programming | 5/2014
Danger of collision!
Use the machine parameter
displayDepthErr to
define whether, if a positive depth is entered, the
TNC should output an error message (on) or not (off).
Keep in mind that the TNC reverses the calculation
for pre-positioning if starting point < end point is
entered. This means that the tool moves at rapid
traverse in the tool axis to set-up clearance below
the workpiece surface!