HEIDENHAIN TNC 128 (77184x-02) - Manual (Page 60)

First Steps with the TNC 128
1.7 Running the first program
1
60
TNC 128 | User's Manual HEIDENHAIN Conversational Programming | 5/2014
1.7 Running the first program
Selecting the correct operating mode
You can run programs either in the
Single Block or the Full
Sequence mode:
Press the operating mode key: The TNC goes into
the
Program Run, Single Block mode and the
TNC executes the program block by block. You
have to confirm each block with the NC start key
Press the
Program Run, Full Sequence operating
mode key: The TNC switches to that mode and
runs the program after NC start up to a program
interruption or to the end of the program
Further information on this topic
Operating modes of the TNC: see "Modes of Operation",
page 65
Running programs: see "Program run", page 332
Choosing the program you want to run
Press the
PGM MGT key: The TNC opens the file
management
Press the
LAST FILES soft key: The TNC opens a
pop-up window with the most recently selected
files
If desired, use the arrow keys to select the
program that you want to run. Load with the ENT
key
Further information on this topic
File management: see "Working with the file manager",
page 98
Start the program
Press the NC start key: The TNC runs the active
program
Further information on this topic
Running programs: see "Program run", page 332