HEIDENHAIN TNC 128 (77184x-02) - Manual (Page 57)

Setting up tools 1.5
1
TNC 128 | User's Manual HEIDENHAIN Conversational Programming | 5/2014
57
The tool table TOOL.T
In the tool table TOOL.T (permanently saved under
TNC:\table\),
save the tool data such as length and radius, but also further tool-
specific information that the TNC needs to perform its functions.
To enter tool data in the tool table TOOL.T, proceed as follows:
Display the tool table
Edit the tool table: Set the
EDITING soft key to ON
With the upward or downward arrow keys you can
select the tool number that you want to edit
With the rightward or leftward arrow keys you can
select the tool data that you want to edit
To exit the tool table, press the END key
Further information on this topic
Operating modes of the TNC: see "Modes of Operation",
page 65
Working with the tool table: see "Enter tool data into the table",
page 150