HEIDENHAIN TNC 128 (77184x-02) - Manual (Page 349)

Machine settings 14.3
14
TNC 128 | User's Manual HEIDENHAIN Conversational Programming | 5/2014
349
14.3 Machine settings
External access
The machine tool builder can configure the external
access options. Refer to your machine manual. Refer
to your machine manual.
With the MOD function External access you can grant or restrict
access to the TNC. If you have restricted the external access it
is no longer possible to connect to the TNC and exchange data
via a network or a serial connection, e.g. with the TNCremo data
transfer software.
Restricting external access:
In the MOD menu select the Machine settings group
Select the
External access menu
Set the
EXTERNAL ACCESS ON/OFF soft key to OFF
Press the
OK soft key
Tool usage file
The tool usage test function must be enabled by
your machine manufacturer. Refer to your machine
manual. Refer to your machine manual.
With the MOD function
Tool usage file you can select whether the
TNC never, once, or always uses a tool usage file.
To generate a tool usage file:
In the MOD menu select the Machine settings group
Select the Tool usage file menu
Select the desired setting for the
Program Run, Full Sequence/
Single Block and Test Run operating modes
Press the
APPLY soft key
Press the
OK soft key