HEIDENHAIN TNC 128 (77184x-02) - Manual (Page 58)

First Steps with the TNC 128
1.6 Workpiece setup
1
58
TNC 128 | User's Manual HEIDENHAIN Conversational Programming | 5/2014
1.6 Workpiece setup
Selecting the correct operating mode
Workpieces are set up in the
Manual Operation or Electronic
Handwheel mode
Press the operating-mode key: The TNC switches
to the
Manual mode of operation
Further information on this topic
Manual Operation mode: see "Moving the machine axes",
page 282
Clamping the workpiece
Mount the workpiece with a fixture on the machine table so that it
is fixed with its edges parallel to the machine axes.