HEIDENHAIN TNC 128 (77184x-02) User Manual
Page 498

Tables and overviews
21.1
Machine-specific user parameters
21
498
TNC 128 | User's Manual HEIDENHAIN Conversational Programming | 5/2014
Parameter settings
Settings for the NC editor
Create backup files
TRUE: Create backup file after editing NC programs
FALSE: Do not create backup file after editing NC programs
Behavior of cursor after deletion of lines
TRUE: Cursor on previous line after deletion (iTNC behavior)
FALSE: Cursor on next line after deletion
Behavior of cursor with first or last line
TRUE: Cursor jumps from end to beginning of program
FALSE: Cursor does not jump from end to beginning of program
Line break with multi-line blocks
ALL: Always display lines completely
ACT: Only display lines of the active block completely
NO: Only display all lines when block is edited
Activate help
TRUE: Always display help graphics during input
FALSE: Only display help graphics when the CYCLE HELP soft key is set to ON. The CYCLE
HELP OFF/ON soft key is displayed in the Programming mode of operation after pressing the
"Screen layout" button
Behavior of soft key row following a cycle input
TRUE: Leave cycle soft key row active after a cycle definition
FALSE: Hide cycle soft key row after a cycle definition
Confirmation request before block is deleted
TRUE: Display confirmation request before deleting an NC block
FALSE: Do not display confirmation request before deleting an NC block
Line number up to which NC program is tested
100 to 9999: Program length for which geometry should be tested
DIN/ISO programming: Block number increment
0 to 250: Increment for generating DIN/ISO blocks in the program
Line number up to which identical syntax elements are searched for
500 to 9999: Search for selected elements with up/down arrow keys
Path specifications for end users
List with drives and/or directories
Drives and directories entered here are shown by the TNC in the file manager
FN 16 output path for execution
Path for FN 16 output if no path has been defined in the program
FN 16 output path for Programming and Test Run operating modes
Path for FN 16 output if no path has been defined in the program