Datum setting without a 3-d touch probe 11.4 – HEIDENHAIN TNC 128 (77184x-02) User Manual

Page 291

Datum setting without a 3-D touch probe

11.4

TNC 128 | User's Manual HEIDENHAIN Conversational Programming | 5/2014

291

Editing the preset table

Editing function in table mode

Soft key

Select beginning of table

Select end of table

Select previous page in table

Select next page in table

Select the functions for preset entry

Activate the datum of the selected line of the
preset table

Add the entered number of lines to the end of
the table (2nd soft-key row)

Copy the highlighted field (2nd soft-key row)

Insert the copied field (2nd soft-key row)

Reset the selected line: The TNC enters - in all
columns (2nd soft-key row)

Insert a single line at the end of the table (2nd
soft-key row)

Delete a single line at the end of the table
(2nd soft-key row)