beautypg.com

4 graphically testing the first part, Selecting the correct operating mode, Selecting the tool table for the test run – HEIDENHAIN TNC 128 (77184x-02) User Manual

Page 53: Graphically testing the first part, Graphically testing the first part 1.4

background image

Graphically testing the first part

1.4

1

TNC 128 | User's Manual HEIDENHAIN Conversational Programming | 5/2014

53

1.4

Graphically testing the first part

Selecting the correct operating mode

You can test programs in the

Test Run mode:

Press the

Test Run operating mode key: the TNC

switches to that mode

Further information on this topic

Operating modes of the TNC: see "Modes of Operation",
page 65

Testing programs: see "Test Run", page 330

Selecting the tool table for the test run

You only need to execute this step if you have not activated a tool
table in the

Test Run mode.

Press the

PGM MGT key: The TNC opens the file

manager

Press the

select type soft key: The TNC shows a

soft-key menu for selection of the file type to be
displayed

Press the

Default soft key: The TNC shows all

saved files in the right window

Move the highlight to the left onto the directories

Move the highlight to the

TNC:\table directory

Move the highlight to the right onto the files

Move the highlight to the file TOOL.T (active tool
table) and load with the ENT key: TOOL.T receives
the status

S and is therefore active for the test run

Press the

END key: Exit the file manager

Further information on this topic

Tool management: see "Enter tool data into the table",
page 150

Testing programs: see "Test Run", page 330