HEIDENHAIN TNC 128 (77184x-02) - Manual (Page 162)

Programming: Tools
5.2 Tool data
5
162
TNC 128 | User's Manual HEIDENHAIN Conversational Programming | 5/2014
Column Meaning
TOKEN TOOL: Tool usage time per TOOL CALL.
The entries are listed in chronological
order.
TTOTAL: Total usage time of a tool
STOTAL: Call of a subprogram; the
entries are listed in chronological order
TIMETOTAL: The total machining time
of the NC program is entered in the
WTIME column. In the PATH column
the TNC saves the path name of the
corresponding NC programs. The
TIME
column shows the sum of all
TIME
entries (feed time without rapid traverse
movements). The TNC sets all other
columns to 0
TOOLFILE: In the PATH column, the
TNC saves the path name of the tool
table with which you conducted the
Test Run. This enables the TNC during
the actual tool usage test to detect
whether you performed the test run
with the TOOL.T
TNR
Tool number (
–1: No tool inserted yet)
IDX
Tool index
NAME Tool name from the tool table
TIME Tool-usage time in seconds (feed time
without rapid traverse movements)
WTIME Tool-usage time in seconds (total usage
time between tool changes)
RAD Tool radius R + Oversize of tool radius
DR from the tool table. (in mm)
BLOCK
Block number in which the
TOOL CALL
block was programmed
PATH TOKEN = TOOL: Path name of the active
main program or subprogram
TOKEN = STOTAL: Path name of the
subprogram
T Tool number with tool index
OVRMAX Maximum feed rate override that occurred
during machining. During Test Run the
TNC enters the value 100 (%)
OVRMIN
Minimum feed rate override that occurred
during machining. During Test Run the
TNC enters the value –1
NAMEPROG
0: The tool number is programmed
1: The tool name is programmed