HEIDENHAIN TNC 128 (77184x-02) - Manual (Page 325)

Graphics 13.1
13
TNC 128 | User's Manual HEIDENHAIN Conversational Programming | 5/2014
325
Detail magnification
You can magnify details in all display modes in the
Program Run,
Single Block and Program Run, Full Sequence operating modes,
as well as in the
Test Run operating mode.
The graphic simulation or the program run, respectively, must first
have been stopped. A detail magnification is always effective in all
display modes.
Changing the detail magnification
The soft keys are listed in the table
Interrupt the graphic simulation, if necessary
In the Program Run, Single Block and Program Run, Full
Sequence operating modes as well as in the Test Run operating
mode, shift the soft-key row until the soft key for the detail
magnification function appears
Shift the soft-key row until the soft key for the
detail magnification functions appears
Select the functions for detail magnification
Press the corresponding soft key to select the
workpiece surface (see table below)
To reduce or magnify the blank form, press and
hold the
minus or plus soft key, respectively
Restart the test run or program run by pressing
the
START soft key (RESET + START returns the
workpiece to its original state)
Function Soft keys
Select the left/right workpiece surface
Select the front/back workpiece surface
Select the top/bottom workpiece surface
Shift the cutting surface for reducing or
magnifying the blank form
Select the isolated detail