HEIDENHAIN TNC 128 (77184x-02) - Manual (Page 495)

Machine-specific user parameters 21.1
21
TNC 128 | User's Manual HEIDENHAIN Conversational Programming | 5/2014
495
Parameter settings
DisplaySettings
Behavior with control start-up
Acknowledge "Power interrupted" message
TRUE: Control start-up is not continued until the message has been acknowledged
FALSE: "Power interrupted" message not displayed
DisplaySettings
Settings for 3-D graphic simulation
Model type of 3-D graphic simulation
3-D (compute-intensive): Model depiction for complex machining operations with
undercuts
2.5-D: Model depiction for 3-axis machining operations
No Model: The model depiction is deactivated
Quality of model in 3-D graphic simulation
very high: High resolution; block end points can be displayed
high: High resolution
medium: Medium resolution
low: Low resolution
ProbeSettings
Configuration of a round stylus
Coordinates of stylus center point
[0]: X coordinate of the stylus center point referenced to the machine datum
[1]: Y coordinate of the stylus center point referenced to the machine datum
[2]: Z coordinate of the stylus center point referenced to the machine datum
Setup clearance above the stylus for pre-positioning
0.001 to 99 999.9999 [mm]: Setup clearance in the tool axis direction
Clearance zone around the stylus for pre-positioning
0.001 to 99 999.9999 [mm]: Setup clearance in the plane vertically to the tool axis