H3C Technologies H3C SecBlade NetStream Cards - Manual (Page 95)

80
To do… Use the command… Remarks
Enter system view system-view ––
Create a policy or policy node
and enter PBR policy node view
policy-based-route policy-name
[ deny | permit ] node
node-number
Required
Define a packet length match
criterion if-match packet-length min-len
max-len
Optional
Define an ACL match criterion if-match acl acl-number Optional
Set an IP precedence apply ip-precedence value Optional
Set outgoing interfaces
apply output-interface
interface-type interface-number
[ track track-entry-number ]
[ interface-type interface-number
[ track track-entry-number ] ]
Optional
Two interfaces at most can be
specified to send matching IP
packets. These two interfaces are
simultaneously active to achieve
load sharing.
For a non-P2P outgoing interface
(broadcast and NBMA interfaces)
such as Ethernet interface, multiple
next hops are possible, and thus
packets may not be forwarded
successfully.
Set next hops
apply ip-address next-hop
ip-address [ direct ] [ track
track-entry-number ] [ ip-address
[ direct ] [ track
track-entry-number ] ]
Optional
Two next hops at most can be
specified. These two next hops are
simultaneously active to achieve
load sharing.
Set default outgoing interfaces
apply default output-interface
interface-type interface-number
[ track track-entry-number ]
[ interface-type interface-number
[ track track-entry-number ] ]
Optional
Two default outgoing interfaces at
most can be specified. These two
interfaces are simultaneously
active to achieve load sharing.
Set default next hops
apply ip-address default next-hop
ip-address [ track
track-entry-number ] [ ip-address
[ track track-entry-number ] ]
Optional
Two default next hops at most can
be specified. These two next hops
are simultaneously active to
achieve load sharing.