H3C Technologies H3C SecBlade NetStream Cards - Manual (Page 264)

249
If you find that an ACTIVE patch is of some problem, reboot the device to deactivate the patch to avoid
faults resulting from patch error.
Follow these steps to activate patches:
To do… Use the command… Remarks
Enter system view system-view —
Activate patches patch active patch-number Required
Confirming running patches
After you confirm the running of a patch, the patch state becomes RUNNING, and the patch is in the
normal running stage. After the device is reset or rebooted, the patch is still valid.
Follow these steps to confirm the running of the patches:
To do… Use the command… Remarks
Enter system view system-view —
Confirm the running of patches patch run patch-number Required
NOTE:
This operation is applicable to patches in the ACTIVE state only.
Step-by-step patch uninstallation
Step-by-step patch uninstallation task list
Task Remarks
Stopping running patches Required
Deleting patches Required
Stopping running patches
When you stop running a patch, the patch state becomes DEACTIVE, and the system runs the way it did
before it was installed with the patch.
Follow these steps to stop running patches:
To do… Use the command… Remarks
Enter system view system-view —
Stop running patches patch deactive patch-number Required
Deleting patches
Deleting patches only removes the patches from the memory patch area, and does not delete them from
the storage media. The patches turn to IDLE state after this operation. After a patch is deleted, the system
runs the way it did before it was installed with the patch.
Follow these steps to delete patches:
To do… Use the command… Remarks
Enter system view system-view —