H3C Technologies H3C SecBlade NetStream Cards - Manual (Page 267)

252
To check if the upgrade is successful after the device reboots, use the display version command.
Hotfix configuration example
Network requirements
• As shown in Figure 78 , the software running on SecBlade is of some problem, and thus hotfixing is
needed.
• The patch file patch_xxx.bin is saved on the TFTP server.
• The IP address of SecBlade is 1.1.1.1/24, and IP address of TFTP Server is 2.2.2.2/24. SecBlade
and TFTP server can reach each other.
Figure 78 Network diagram of hotfix configuration
Configuration procedure
1. Configure TFTP Server. The configuration varies depending on server type and the configuration
procedure is omitted.
• Enable the TFTP server function.
• Save the patch file patch_xxx.bin to the directory of the TFTP server.
2. Configure SecBlade
CAUTION:
Make sure the free space of cfa0 of the device is large enough to store the patch file.
# Before upgrading the software, use the save command to save the current system configuration. The
configuration procedure is omitted.
# Load the patch file patch_xxx.bin from the TFTP server to the root directory of the device storage
media.
tftp 2.2.2.2 get patch_xxx.bin
# Install the patch.
system-view
[SecBlade] patch install cfa0:
Patches will be installed. Continue? [Y/N]:y
Do you want to continue running patches after reboot? [Y/N]:y
Installing patches........
Installation completed, and patches will continue to run after reboot