beautypg.com

H3C Technologies H3C SecBlade NetStream Cards User Manual

Page 52

background image

37

To do…

Use the command…

Remarks

Create a local user and enter local
user view

local-user user-name

By default, no local user exists.

Set the local password

password { cipher | simple }
password

Required
By default, no local password is set.

Specifies the command level of the
local user

authorization-attribute level
level

Optional
By default, the command level is 0.

Specify the service type for the local
user

service-type telnet

Required
By default, no service type is specified.

Exit to system view

quit —

Configure common settings for VTY
user interfaces

Optional
See “

Configuring common settings for

VTY user interfaces (optional)

.”

When users adopt the scheme mode to log in to the SecBlade card, the level of the commands that the

users can access depends on the user privilege level defined in the AAA scheme.
For more information about AAA, RADIUS, and HWTACACS, see the Security Configuration Guide.
When you log in to the SecBlade card through telnet again:

You are required to enter the login username and password. A prompt such as appears
after you enter the correct username (for example, admin) and password and press Enter, as shown

in

Figure 15

.

After you enter the correct username and password, if the SecBlade card prompts you to enter
another password of the specified type, you will be authenticated for the second time. In other

words, to pass authentication, you must enter a correct password as prompted.

If “All user interfaces are used, please try later!” is displayed, it means the current login users
exceed the maximum number. Please try later.

Figure 15 Configuration page