Modifying the level of a command, Saving the current configuration, Displaying and maintaining cli – H3C Technologies H3C SecBlade NetStream Cards User Manual
Page 34

19
Modifying the level of a command
All the commands in a view default to different levels. The administrator can change the default level of
a command to a lower level or a higher level as needed.
Follow these steps to modify the command level:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Configure the command level in a
specified view
command-privilege level level view
view command
Required
See
for the default settings.
CAUTION:
H3C recommends you to use the default command level or modify the command level under the guidance
of professional staff. An improper change of the command level may bring inconvenience to your
maintenance and operation, or even potential security problems.
Saving the current configuration
On the device, you can input the save command in any view to save all the submitted and executed
commands into the configuration file. Commands saved in the configuration file can survive a reboot.
The save command does not take effect on one-time commands, such as display commands, which
display specified information, and the reset commands, which clear specified information. The one-time
commands executed are never saved.
Displaying and maintaining CLI
To do…
Use the command…
Remarks
Display defined command aliases
and the corresponding commands display command-alias
Available in any view
Display the clipboard information display clipboard
Available in any view