H3C Technologies H3C SecBlade NetStream Cards - Manual (Page 163)

148
To do… Use the command… Remarks
Configure the source interface
for NetStream traditional data
export ip netstream export source
interface interface-type
interface-number
Optional
• By default, the interface where the
NetStream data is sent out (the interface
connects to the NetStream server) is used
as the source interface.
• H3C recommends you connect the
network management interface to the
NetStream server and configure it as the
source interface.
Limit the data export rate ip netstream export rate rate
Optional
No limit by default.
Configuring NetStream aggregation data export
Follow these steps to configure NetStream aggregation data export:
To do… Use the command… Remarks
Enter system view system-view —
Enter interface view
interface interface-type
interface-number
—
Enable IPv4 NetStream
ip netstream { inbound |
outbound }
Required
Disabled by default.
The outbound keyword does not take effect
on SecBlade NetStream cards.
Exit to system view quit —
Set the IPv4 NetStream
protocol-port aggregation mode
and enter its view
ip netstream
aggregation
protocol-port
Required
Configure the destination address
for the IPv4 NetStream
aggregation data export
ip netstream export host
ip-address udp-port
Required
By default, no destination address is
configured in NetStream aggregation view.
Its default destination address is that
configured in system view, if any.
If you expect to export only NetStream
aggregation data, configure the destination
address in related aggregation view only.
Configure the source interface for
IPv4 NetStream aggregation data
export
ip netstream export
source interface
interface-type
interface-number
Optional
By default, the interface connecting to the
NetStream server is used as the source
interface.
• If no source interface is configured in
aggregation view, the source interface
configured in system view, if any, is used.
• H3C recommends you connect the
network management interface to the
NetStream server.