H3C Technologies H3C SecBlade NetStream Cards - Manual (Page 50)

35
By default, you can log in to the SecBlade card through the console port without authentication and have
user privilege level 3 after login. For information about logging in to the SecBlade card with the default
configuration, see “
Configuration requirements .”
Configuration procedure
Follow these steps to configure password authentication for telnet login:
To do… Use the command… Remarks
Enter system view system-view —
Enable telnet telnet server enable
Required
By default, the telnet service is
disabled.
Enter one or multiple VTY user
interface views user-interface vty first-number
[ last-number ]
—
Specify the password
authentication mode
authentication-mode password
Required
By default, authentication mode
for VTY user interfaces is
password.
Set the local password
set authentication password { cipher |
simple } password
Required
By default, no local password is
set.
Configure the user privilege level
for login users
user privilege level level
Required
0 by default.
Configure common settings for
VTY user interfaces
—
Optional
See “
Configuring common
settings for VTY user interfaces
(optional) .”
When you log in to the SecBlade card through telnet again, perform the following steps:
• You are required to enter the login password. A prompt such as appears after you enter the
correct password and press Enter, as shown in
Figure 14 .
• If “All user interfaces are used, please try later!” is displayed, it means the number of current
concurrent login users exceed the maximum. Please try later.