H3C Technologies H3C SecBlade NetStream Cards - Manual (Page 120)

105
To do… Use the command… Remarks
Create a subinterface of the
ten-GigabitEthernet interface and
enter subinterface view
interface ten-gigabitethernet
interface-number.subnumber
Required
The subnumber must be one of the
VLAN IDs created on the host
device.
Configure the operating mode of
the subinterface as Layer 2
port link-mode bridge
Required
Layer 2 by default.
Configure the link type of the
subinterface as access
port link-type access
Optional
By default, the link type of a
subinterface is access.
Assign the subinterface to the
VLAN of the SecBlade card
port access vlan vlan-id Required
Create another subinterface and
enter subinterface view interface ten-gigabitethernet
interface-number.subnumber
Required
The subnumber must be the ID of the
other VLAN created on the host
device.
Configure the operating mode of
the subinterface as Layer 2
port link-mode bridge
Required
Layer 2 by default.
Configure the link type of the
subinterface as access
port link-type access
Optional
By default, the link type of a
subinterface is access.
Assign the subinterface to the
VLAN of the SecBlade card
port access vlan vlan-id Required
Displaying and maintaining inter-VLAN Layer 2 forwarding
To do… Use the command… Remarks
Display VLAN information
display vlan [ vlan-id1 [ to vlan-id2 ] | all |
dynamic | reserved | static ]
Available in any view
Display brief
interface/subinterface
information
display interface [ interface-type
[ interface-number |
interface-number.subnumber ] ] [ | { begin |
exclude | include } regular-expression ]
Available in any view
Display interface/subinterface
state and related information
display interface [ interface-type
[interface-number |
interface-number.subnumber ] ]
Available in any view
Clear the interface/subinterface
statistics
reset counters interface [ interface-type
[ interface-number |
interface-number.subnumber ] ]
Available in any view