beautypg.com

Outputting system information to the trap buffer – H3C Technologies H3C SecBlade NetStream Cards User Manual

Page 283

background image

268

To do…

Use the command…

Remarks

Specify the source IP address for
the log information

info-center loghost source
interface-type

interface-number

Optional
By default, the source interface is

determined by the matched route, and the
primary IP address of this interface is the

source IP address of the log information.

Configure the format of the time
stamp for system information

output to the log host

info-center timestamp loghost
{ date | iso | no-year-date |

none }

Optional
date by default.

Set the format of the system
information sent to a log host to

UNICOM

info-center format unicom

Optional
H3C by default.

Specify a log host and configure
the related output parameters

info-center loghost
host-ipv4-address [ port
port-number ] [ channel

{ channel-number |

channel-name } | facility
local-number ] *

Required
By default, the system does not output

information to a log host. If you specify to
output system information to a log host,

the system uses channel 2 (loghost) by

default.
The value of the port-number argument
should be the same as the value

configured on the log host, otherwise, the

log host cannot receive system
information.

Outputting system information to the trap buffer

NOTE:

The trap buffer receives the trap information only, and discards the log and debugging information even
if you have configured to output them to the trap buffer.

To do…

Use the command…

Remarks

Enter system view

system-view

Enable information center

info-center enable

Optional
Enabled by default

Name the channel with a
specified channel number

info-center channel channel-number
name channel-name

Optional
See

Table 19

for default channel

names.

Configure the channel
through which system

information can be output to
the trap buffer and specify the

buffer size

info-center trapbuffer [ channel
{ channel-number | channel-name } |
size buffersize ] *

Optional
By default, system information is
output to the trap buffer through

channel 3 (known as trapbuffer)

and the default buffer size is 256.