Displaying and maintaining static routes, Static route configuration example, Network requirements – H3C Technologies H3C SecBlade NetStream Cards User Manual
Page 91: Configuration procedure

76
Displaying and maintaining static routes
To do…
Use the command…
Remarks
Display information of static routes
display ip routing-table protocol static [ inactive |
verbose ]
Available in any
view
Delete all the static routes
delete static-routes all
Available in
system view
Static route configuration example
Network requirements
SecBlade is connected remotely to NSC, as shown in
. Assuming that Device A and Device B
can communicate with each other, configure a static route so that SecBlade can communicate with NSC.
Figure 25 Network diagram for static route configuration
Configuration procedure
1.
Configuring IP addresses for interfaces (omitted)
2.
Configuring a static route
# Configure a static route on SecBlade.
[SecBlade] ip route-static 1.1.3.0 255.255.255.0 1.1.4.2
3.
Configure the host.
On NSC, configure the default gateway as 1.1.3.1. The configuration procedure is omitted.
4.
Verify the configuration
# Display the IP routing table of SecBlade.
[SecBlade] display ip routing-table
Routing Tables: Public
Destinations : 3 Routes : 3
Destination/Mask Proto Pre Cost NextHop Interface